Skip to content
GuideEvergreen guide

Three miles from the truck, the knife work starts with a plan

Bone-in quarters are a bad bet when you're carrying everything on your back. Here's how to break down an animal where it fell and get clean meat out.

By Wes Dunbar · Country & Skills6 min read
Three miles from the truck, the knife work starts with a plan

Quick answer: Get the meat off the ground, keep it clean, and get it cool. Then decide before the first cut what you'll haul out and in how many trips. Check your state's rules on bone-in transport and proof of sex first, because they decide how you can butcher.

Decide before you cut

Most trouble out here starts with the animal itself. It dropped in a drainage a mile and a half below the ridge, the sun is going down, and you're looking at a pack that was built for a day hunt.

Stop and do the math before you touch the knife. How far is the carry? How many trips will it take? How many hours of light do you have? Meat that's been skinned and sitting in warm air is on a clock, and the clock runs faster when the weather's mild. The usual food-safety target is 40°F or below. Know your timeline and your weather.

Then check what the law lets you do. Regulations vary by state, province and even by management unit. Some places require evidence of sex to stay attached to the carcass or meat until it's processed. Some require you to leave the bone in. Others restrict moving spine and brain tissue out of chronic wasting disease zones. Tag rules differ too. Read the current regulation booklet for the unit you're actually hunting. If it's unclear, call the game agency before you go in. A phone call costs nothing. A citation costs a lot.

Why the gutless method fits

The gutless method means you never open the body cavity. You skin one side, take the meat off in big pieces, flip the animal, and do the other side. You leave the guts and bones where they lie.

It has real advantages when you're far from a road:

  • Less weight. You're not hauling bone, hide or organs you don't plan to eat.
  • Cleaner meat. The gut never gets cut, so there's nothing to spill on the meat.
  • No dragging. You work on the spot where the animal fell, without wrestling it uphill.

The trade-offs are just as real. It's slower at first, and a first-timer shouldn't be surprised when it takes a couple of hours. You also need to know where the tenderloins are and how to get to them. And if your unit requires bone-in quarters, this method is out. Read the booklet.

Set up the work area

Pick the flattest spot nearby, even if that means moving the animal a few yards. Look for shade. Look for something to keep the meat off the dirt, like rocks, a log, or a clean branch pile.

Lay out your game bags where you can reach them. Put your headlamp on before you need it. Get a small bag of water and a rag within arm's reach, because your hands will be slick and a knife only helps if you can hold it.

Wear gloves. Cut away from your body and away from your off hand. Keep the knife sharp, and stop to touch it up when it starts to drag. A dull knife slips and a slipped knife in a bloody hand is how real injuries happen out here. I'll say more about what to carry in your knife, your saw, and what else the pack has to carry.

The order of work

Follow a consistent sequence every time. It's the simplest way to avoid forgetting a cut.

  1. Skin the upturned side. Cut from the hamstring up and around, and peel the hide back. Lay it hair-side down so the hide becomes your clean tarp. Work away from the carcass, not through it.
  2. Take the front shoulder. It's held on by muscle and connective tissue, not a joint. Pull it away from the ribs and cut along the inside. It comes off cleaner than you'd think.
  3. Take the backstrap. Cut along the spine from the base of the neck to the hip, then peel the strip off the ribs. This is the best meat on the animal, so keep it clean.
  4. Take the hindquarter. Work the knife around the hip joint and follow the bone. On a deer you can pull it off whole. On an elk it's heavy enough that most people debone it right there.
  5. Take the neck meat and rib meat. They're worth the effort. Trim and bag them.
  6. Get the tenderloins. These sit inside the body, along the underside of the spine. On a gutless job you can reach them through the cavity wall once the side is open, or after you flip the animal.
  7. Roll the animal and repeat on the other side.

As each piece comes off, put it in a bag or on a clean surface. Don't set it on the ground. Keep the cut surfaces away from hair, leaves and dirt, and wipe off what lands on them. A lot of tainted meat starts out as a minute of carelessness.

If you're hunting where chronic wasting disease has been found, don't cut through the spine, and leave the head and spinal column where your local rules say to. Many states ask hunters to dispose of those parts at designated sites. Check before you go.

Bone out or leave it on

If the regulation lets you, boning out on the spot saves a lot of weight. A bone-in elk hindquarter can be a serious burden, and a boned-out one rides in the pack much better. A deer is easier either way.

If you must keep bone in, be honest about your own limits. Quartering a larger animal in several trips is still a valid choice. A pack that's too heavy for your knees on a steep descent is a bad bet. Getting hurt on the way out is the real way these hunts go wrong.

Packing it out

Load the heaviest pieces high and close to your spine. Pad the bags so blood doesn't soak your gear. Pack the backstraps and tenderloins somewhere you can keep an eye on them.

If it's more than one trip, take the best cuts first. The meat left behind should sit in shade, off the ground, in breathable game bags. A tarp over the top keeps the sun and the birds off. In bear country, don't leave meat hanging near where you camp, and carry bear spray if local wildlife officials recommend it. Move the leftover meat as far from the trail as you can, and plan to be back quickly. Ask the game agency what they expect hunters to do about the gut pile near trails and trailheads.

Tell someone where you're going and when you expect to be back before you leave. A text from the trailhead takes ten seconds. If something goes sideways, that note is what gets people looking in the right place. For solo work, field dressing alone and getting the meat out covers more of the sequence.

Leave it better than you found it

Pick up every glove, scrap of flagging tape, and piece of string. Pack out your game bags if they're ruined. Shake out your gear before you leave so you're not scattering hair and fat across the hillside.

Respect the land you're on. If you hunt public ground, you're a guest on it, and the next hunter will see exactly what you left behind. If you're still figuring out where to go, where to hunt when you don't own a single acre is a good place to start.

The hard part of the hunt is already over when the animal goes down. What you do next decides whether the meat ends up in the freezer or in the brush.

Wes Dunbar

Country & Skills

Grew up on an acreage and never quite left. Covers trucks, trades, land, and how to do the thing yourself.

Watch

Worth an hour of your evening

More from Hunting & Shooting.

From channels we rate. Plays on YouTube.

    Hunt Factory Inc.Sep 13

    Don't Aim, Point The Shotgun: Tips For Better Shotgun Wing Shooting & Duck Hunting

    Surviving Duck SeasonJun 18

    How to Hit More Ducks | feat Jimmy Muller | Shotgun Series

    Chasing GreenJun 19

    20 Duck Hunting Tips in 3 Minutes

    Hunt Factory Inc.Aug 30

    Don't Shoulder The Shotgun: Shotgun Wing Shooting & Duck Hunting