Skip to content
GuideEvergreen guide

Check the color of your power steering fluid this weekend

The fluid goes dark and gritty long before the pump whines. Two minutes with a flashlight and a paper towel tells you which side of that line you're on.

By Dean Shaw · Gear & Garage6 min read
Check the color of your power steering fluid this weekend

Quick answer: Healthy power steering fluid is clear and bright, in whatever color it came from the factory. Dark brown, black, milky or gritty fluid is a warning. Change it before the pump starts whining, because by the time you hear it, the damage is done.

The fluid that gets ignored

You check the oil. Maybe the washer fluid. The power steering reservoir sits off to one side with a little cap, and most guys go years without lifting it.

That's a mistake, because the pump and rack are two of the more expensive things under the hood to replace, and the fluid is the cheapest warning you'll get. It works hydraulically. It also lubricates and carries heat. As it wears, it carries tiny bits of metal and rubber from the pump, the hoses and the rack seals. The color tells you how that's going.

First, find out if you even have it

Plenty of newer cars have electric power steering. There's a motor on the column or the rack and no fluid at all. Open the owner's manual, find the steering section, and see. If it says nothing about fluid, you're done and you can skip this piece.

If you do have a hydraulic system, the reservoir is usually a small plastic tank near the belt end of the engine, with a cap marked with a steering wheel icon or the words "power steering." Some caps have a short dipstick attached. Others have MIN and MAX lines molded into the side of a translucent tank.

How to do the check

Park on level ground. Let the engine sit until it's cool, or at least warm rather than hot. Many dipsticks have both a HOT and a COLD mark, so read the right side of it.

Wipe the cap before you open it. Dirt that falls in does more harm than the fluid ever will. Pull the dipstick, wipe it on a white paper towel, and look at the stain in daylight, not under the garage bulb.

Pay attention to three things: the color, the clarity and the smell. Then compare it to the label in the manual or on the cap, because the starting color depends on the fluid. Some are red, some amber, some nearly clear, and a few import-specific fluids look quite different from each other. That's why guessing from a chart on the internet is risky. Your manual is the authority on what goes in.

What the color is telling you

Same as new, translucent. Leave it alone. Check it again in a few months.

Slightly darker than new, still see-through. Normal for a car with some miles on it. Put it on your list for the next service.

Dark brown or black. The fluid is cooked. Heat has broken it down, and it's no longer protecting the pump. If it also smells burnt, like scorched toast, the pump has been running hot for a while, often from a restricted hose or from years of use without a change.

Milky, foamy or tan. Air or moisture is getting in. A loose hose clamp, a leaking return line or a failing seal can do it. Don't just top it off and hope. Find the leak.

Glitter or grit on the paper towel. Those are metal particles from wear. Rub a little between your fingers. If you feel grit, the pump or rack is already shedding material, and fresh fluid may slow it but won't undo it.

Topping off doesn't fix it

This is where most people go wrong. The level is a little low, so they pour in a bottle of whatever the parts store had on the shelf. Now they've got old, worn fluid mixed with the wrong new fluid.

Using the wrong type matters more than it sounds. Some systems call for a specific power steering fluid. Others take certain automatic transmission fluids. Some manufacturers want their own formula and nothing else. The seals are designed around that chemistry. If your manual names a fluid, buy exactly that.

If the fluid is low, ask why. A system is supposed to be sealed. Dropping a quart over a year means a leak somewhere. Look at the hoses, the pump body and the rack boots for wetness or a crust of dirt stuck to oil. Look at the ground where you park.

The cheap fix most people skip

If the fluid is dark but the pump is quiet and the steering feels normal, you've caught it in time. A full professional flush is one route. The do-it-yourself version is simpler, and it's worth trying on an older car that's otherwise sound.

Use a clean turkey baster, or a fluid extractor from the parts store, to pull as much fluid out of the reservoir as you can. Refill to the full line with the correct new fluid. Start the engine, turn the wheel gently from side to side a few times, shut it off, and check the level again. Repeat that cycle a few times over a week or two and the fluid lightens as the old stuff dilutes out.

It won't be as thorough as a shop flush, since the rack and hoses keep some old fluid. But it costs very little, and it leaves the system in a lot better shape than you found it.

If you'd rather hand it off, that's fine too. Just ask the shop what fluid they're using and make sure it matches your manual. A shop that says "universal" without checking has told you something about how careful they are.

Listen for what the color already told you

By the time the pump is whining, the fluid has usually been bad for a long time. The sound comes first when you turn the wheel hard at low speed, most often on a cold morning. Then comes a stiffer feel, or a groan when you crank it to full lock in a parking lot.

One habit worth breaking: don't hold the wheel against the stop at full lock for more than a second or two. That forces the pump to push against a wall and cooks the fluid fast.

If you hear the whine, check the fluid immediately. Low and foamy usually means a leak or air in the system, and the pump may still be saved if you fix it fast. Dark and gritty means the pump is wearing and the clock is running.

Where this fits

Fluid checks belong in the routine you run before a long trip or when you're sizing up a used car. Twenty minutes with the engine off tells you most of it covers the rest of that walkaround. If you're sorting out which jobs can wait and which can't, the car servicing that can't wait, and the kind that can puts this one on the right side of the line. And if you're aiming to keep a car on the road for the long haul, what it really takes to get a car past 250,000 miles is the bigger picture.

Do it this weekend. Pop the cap, wipe the stick, hold it up to the light. If it's clean, you've spent two minutes. If it's black, you've just saved yourself the pump.

Dean Shaw

Gear & Garage

Reads the warranty, the parts list and the long-term owner reviews before anything else. Trucks, tools, watches, and the cheap version that costs more.

Watch

Worth an hour of your evening

More from Cars.

From channels we rate. Plays on YouTube.

    Doug DeMuroNov 20

    Audi Nuvolari Pricing Has Been Announced!

    Doug DeMuroNov 20

    $29,990 Tesla Cybercab! New Cheap Manual Truck? Baby Defender Concept! THIS CAR POD! EP138

    Doug DeMuroNov 19

    Another Luxury Sedan Has Been Cancelled

    EricTheCarGuySep 1

    A Mechanics Guide To Maintaining Your Car